Gearing Dynamics - Designers and Manufacturers of Specialised 4x4 Driveline Technology for Toyota Landcruisers
Gearing Dynamics - Designers and Manufacturers of Specialised 4x4 Driveline Technology for Toyota Landcruisers
Gearless Centre Differential
How it Works
Manuals
Fitting
Current Users
CV Boot
Exhaust Brake
Airbag Suspension
Radiator
Contact us
Greasable CV Joints
Home

UNIQUE and SPECIAL PRODUCTS
Designed and manufactured for the
Mining Industry Toyota Landcruiser

 
  • Axle wind-up in the Toyota part time transfer case causes a multitude of high maintenance problems through the driveline.
  • The vehicle is also difficult to drive as it pushes straight ahead in corners.
  • Well … no more! The Gearless centre Differential converts the Toyota into a smooth, safe and robust workhorse.
  • First available for the 75 series since 1990… Two variants – dedicated Low Range or Dual Range are available to suit all Toyota cab chassis including 78/79 and the new 70 series V8.
  •  
  • CV Joints need grease INSIDE the cage for maximum life.
  • A grease nipple in the end of the shaft allows for quick and effective greasing from inside the CV whilst still in the vehicle.
  • Our pressure relief valve stops excessive grease pressure blowing past the inner axle seal into the axle tubes.
  •  
  • Specifically designed for underground mining heat.
  • This heavy duty built tougher for tough conditions. It is thicker, has twice the number of tubes with wider fins and is solder coated for extra strength to withstand corrosion and pressure cleaning.
  • A low water port with sender can be included if required.
  •  
  • Needed for years and now available.
  • Quick and easily fitted, the boot fully protects and stops contamination from water, corrosion abrasion and rocks destroying the expensive axle housing.
  • STEEL FAN & HUB KIT Toyota Landcruiser 75,78,79
     
  • Heavy duty cooling.
  • The steel fan is coupled with a steel connecting hub to replace the standard plastic fan and clutch hub. Always spins at the engine revs.
  • Maintenance free and much more effective especially in deeper water situations that suck the plastic fan forward into the radiator.
  •  
  • Suits 2.5” or 3” exhaust pipe dia.
  • When you’re fully loaded or you’re towing the van and there’s hills up ahead, you definitely need assistance for the brakes. Loss of brake pedal on a downhill run is a danger best prevented before it occurs. An Exhaust brake designed for the small diesel engine is the perfect solution for safety and peace of mind.
  • A simple vacuum operated butterfly valve uses the engines compression for extra retard and will extend pad life. Automatically controlled from microswitches on the accelerator and clutch with an over-ride switch to turn it off.
  • FIXED FRONT DRIVE FLANGES
     
  • Designed for when permanent 4WD is required without the need to be unlocking the hubs. Fit and forget to reduce maintenance and keep the front wheels driving at all times.
  • A complete kit consisting of a flange, cap, step washer to hold the CV joint in the correct position, and assembly bolt.
  •  
  • Toyota Landcruiser and Hilux
  • Toyota springs always seem a bit light. Boost up the rear load height with air bag suspension assist. Easily adjusted to suit the load on board and the ride comfort you want.

  • Proven Performance and Reliability for Toyota Landcruisers - for over 20 years!

    Gearing Dynamics - Designers and Manufacturers of Specialised 4x4 Driveline Technology for Toyota Landcruisers

     

    26 HUME RESERVE COURT,
    NORTH GEELONG,
    VICTORIA, 3215
    AUSTRALIA


    Phone: 03 5272 2844
    Fax::    03 5272 2633

    www.gearingdynamics.com

    welcome creek web design

     

     

    Site Meter